Surveillance WebCam Product Documentation   Home Page    Table of Contents

Example Remote User Interface

The following example shows the Remote User Interface, logging onto the Program, getting the Admin Page with all the remote commands, then logging off  and closing the browser.

In the Video Surveillance WebCam Software click on menu item Settings, Remote User Interface. 

Result: should be the Web Server Program starts, the Web Browser opens up, and connects the Video Surveillance WebCam Software's Logon Page as seen below.

Log On Page

Enter Password

 

Click enter or enter your password then click enter.

Result: you see the Home Page as shown below.

Home Page

User Page
Mobile User Page
Admin Page
Mobile Admin Page
Media Player Page

Log Off

In the Home Page, click on link Admin Page.

Result: you should see the Admin Page as shown below. It has all the remote commands, some of which are found in the other web pages.

Admin Page

Shortcuts Down this page

Arm Alarms Startup
Logon Save FTP
Status Motion Detection Load Config
Review Video Switching Close Files
Remote View Video Audio
File Streaming Files Bottom

Re-Log On to Program if Log On Timed Out

Enter Password

Log Off

From Admin Page above, click on link Log Off.

Result: you get a message that says,  Logged Off OK.

Now close the web browser.

That is the end of a simple remote communications session with the Video Surveillance WebCam Software.

Observe:

  1. For there to be remote communications the Web Server Program must be running.
  2. That in the web browser one enters http://ComputerIPAddress/logon.htm

Troubleshooting:

if this example or menu item Remote User Interface does not work try example manually with your web browser.

possible causes of error: